Search results for: 'wiring kit'

Low Profile, 2.25" (5.7cm) extension from wall

Stainless Steel & Brass construction

Square Base with Round Bar

Easily mounts to any wall surface

Low Profile, 2.25" (5.7cm) extension from wall

Stainless Steel & Brass constuction

Round Base with Round Bar

Easily mounts to any wall surface

Low Profile, 2.25" (5.7cm) extension from wall

Stainless Steel & Brass constuction

Round Base with Round Bar

Easily mounts to any wall surface

Constructed of Low Lead solid Brass for durability

cUPC certified to meet both the American and Canadian Uniform Plumbing Codes

Brass Cartridge

Easy to install

90° swiveling spout

For either cold or hot water, Red/Blue indicators included

GP-1000
Modified Sine Wave Inverter
1000 Watts -12 volt
Length: 13.5 Inches (34.29 cm)
Width: 12 Inches (30.48 cm)
Height: 3.5 Inches (8.89 cm)
Weight: 4.2 lbs (1.91 kg)
Go Power! 1000-Watt Modified Sine Wave Inverter takes in 12 Volt DC power and converts it to AC household power to run loads up to 1000-Watt of continuous power. This inverter comes with two AC outlets and can be hooked up to the batteries using GP-DC-KIT2 and can surge to 1300-Watt as well as contains all instructions.

To be wired in parallel with other relay coils within the Master Control Circuit  

Coil - 12VDC

Contacts - 30A @ 120/277 VAC

                    20A @ 28 VDC (low voltage)

Includes:
3- 120 VAC illuminated switches
3-13.5VDC illuminated switches
1 - 5 gang switch plate with raised mounting bezel, labeled (Fresh, Gray, Black)
15 - quick slide female connectors,
4 - mounting plate screws
2 - blanks (to cover switchcutouts if all 5 switches are not used)

Each switch is rated for 20 Amps maximum, indifferent to voltage rating.

Includes:

5- 13.5VDC illuminated switches,
1 - labeled (Fresh, Gray, Black) 5 gang switch plate with raised mounting bezel
15 - quick slide female connectors,
4 - mounting plate screws
2 - blanks (to cover switchcutouts if all 5 switches are not used)

Each switch is rated for 20 Amps maximum

Includes:

3- 120 VAC illuminated switches

1 - labeled switch platewith raised mounting bezel
9 - quick slide female connectors,
4 - mounting plate screws

Each switch is rated for 20 Amps maximum.

Includes:

1- 120 VAC illuminated switch
2 - Labeled switch plates
(1-Tank, 1-Pipe/Elbow)
1 - Raised Mounting Bezel
3 - quick slide female connectors,
2  -mounting plate screws

Switch is rated for 20 Amps maximum

Includes:

1 - 13.5 VDC illuminated switch
2 - Labeled switch plates
(1-Tank Heater, 1-Pipe/Elbow Heater)
1 - Raised Mounting Bezel
3 - quick slide female connectors,
2 - mounting plate screws

Switch is rated for 20 Amps maximum